Supplies

Ridges are produced in different colors and are also available in two roofing design options: Ridges are Produced in variety of colors and for the roofing there are two design options: semicircular-saddle with hood of the 1000 mm length level-prismatic, with an optional cover That has a length (this is defined by the length of the ridge) Ridge on the sub-structure is attached through the base by covering and fastening with screws for firm securing of the roofing. Special version ridge is so-called ridge ventilation, Which we manufacture per order ACCORDING tothe exact and specific parameters of the roof.
Screws are used for fixing the sheet metal to the roof, wall or ceiling on the sub-structure, they are a very important element. All screws in our offer are well protected with a coating of zinc in thickness of 20 mm and a coat of paint of 50 microns, which is very important for screws that are exposed to external influences. Moreover all screws are equiped with aluminum washers with a neoprene pad which has the following characteristics: They are made from the finest materials to seal - EPDM, with aging they do not lose elasticity long life (minimum 30 years) compensates for the effects of thermal spread and. shrinkage material (1cm / 10m) resistant to changing weather conditions and UV radiation after installation this creates a waterproof layer, retains properties on the influence of high temperature within the range of +50 °C to 120 °C. screws Screws, according to the sub-structure are divided into two groups: bolts to metal plates, and screws for wood and concrete sub-structure. All screws are self-tapping, the maximum length is 150 mm and a maximum diameter is 12.00 mm. They are available in the following colors: red (RAL 3009), dark brown - chocolate (RAL 8017), brick red (RAL 8004), white (RAL 9002), black (RAL 9005), Silver (9006) zinc, as well as in other colors when ordering larger quantities.
003 The wind lath has the function to protect the roofing sheets from side winds. It also has the esthetic function. Depending on the type of the wind lath, the installation is done before or after the installation of roofing sheets.
A roof valley can serve to collect and drain roof water, or it can have the function of the roof gutter. The roof valley is installed before the installation of roofing sheets.
Drip edge closes the space between the roofing and gutter. The main function is the proper water drainage from the roof into the gutter (to prevent possible recourse). Since the lower cover edge of the roof also has an aesthetic function.
Chimney flashing has the same function as wall flashing. The flashing is installed together with the roofing sheets.
Classical snow barriers prevent slipping snow from the roofs. They are made of sheet metal in the color of the roofing with length of the 1200 mm. screwed with screws for fastening sheet metal roofing (8 pieces per 1 snow- stopping unit ). Snow barriers are raised alternately in two rows along the entire length of the roof from the eaves to the length of 6 m, and in these three rows in the length of the eaves of 6 m. Mandatory snow-stopping unit is mounted in each ad Queuing window.